This guide will walk you through how to replace your safety key magnetic switch for the NoblePro Elite E8 series treadmills. This might be necessary if the treadmill does not detect the safety key when place correctly in position. What will I need? Philips (star) screwdriver Replacement safety key cables
This page contains the instructions to replace the running board [60] for the NoblePro Elite Series treadmills (NPE78848E8is, NPE78844E8i, NPE78847E8s, NPE78843E8.0). WARNING: Mains voltage can be dangerous. Ensure the needed safety precautions are taken before undertaking these instructions. What will I need? To undertake the replacement you will need: Replacement
This page contains the instructions to replace the motor controller board (MCB) for the NoblePro Elite Series (NPE78848E8is, NPE78844E8i, NPE78847E8s, NPE78843E8.0). WARNING: Mains voltage can be dangerous. Ensure the needed safety precautions are taken before undertaking these instructions. What will I need? To undertake the replacement you will need: 1.
This page contains the instructions on how to replace or install the communication cable on a NoblePro Elite E8 Series treadmill. What will I need? To undertake the installation you will need: 1. Replacement cable 2. Star screwdriver 3. 2 x 3mm cable ties 4. 6mm Allen Key 5. Cable
If your treadmill is making a knocking noise when on a slight incline it could be that the frame is touching the bump stops. It might be worth trying the treadmill without the bump stops installed or increasing the treadmill incline slightly. What are bump stops? The bump stops are
Need help? Starting your support request online and we’ll connect you to the Support Team.
