NoblePro Elite Series – Running Board Replacement

Elite Series – Running Board Replacement

Introduction

This page contains the instructions to replace the running board [60] for the NoblePro Elite Series treadmills (NPE78848E8is, NPE78844E8i, NPE78847E8s, NPE78843E8.0).

WARNING: Mains voltage can be dangerous. Ensure the needed safety precautions are taken before undertaking these instructions.

What will I need?

To undertake the replacement you will need:

  • Replacement running board.
  • Star screwdriver.
  • 6mm allen key

!Safety first!

Turn off the treadmill by the wall and unplug the cable from the treadmill power socket and wait 20 mins for the capacitors to discharge.

Removing the foot rails

1. Remove the motor cover by removing the 4 retaining screws.

2. Remove the rear corner covers [84 & 85]

3. Remove foot rail fixing screws on the motor side

4. Remove foot rail fixing screws on the underside of the running board near the back

5. Remove the foot rails by sliding them away from the motor side of the treadmill

Removing the rear roller

6. Using a 6 mm allen key remove the rear roller bolts [82]

7. Remove the rear roller

Removing running belt

8. Remove the screws holding the running board [60] to the frame [2]
– 4 x [66]
– 2 x [67]

9. Slide the running belt [60] our from under the running belt [73]

Installing the new board

10 . Remove the foot rail guides 8 x [79] from the old board and place them on the new board

11.  Slide the new board into place on the frame [2]

12. Reinstall the screws holding the running board [60] to the frame [2]
– 4 x [66]
– 2 x [67]

Reinstall the rear roller

13. Place the rear roller [81] in position

14. Using a 6 mm allen key reinstall the rear roller bolts [82]

Note: at this stage only lightly tension belt. Final tensioning and alignment will take place at the end.- 

Reinstalling the foot rails

15. Reinstall the foot rails by sliding them towards the motor side of the treadmill

16. Reinstall the foot rail fixing screws on the underside of the running board near the back

17. Reinstall the foot rail fixing screws on the motor side

18. Reinstall the rear corner covers [84 & 85]

19. Reinstall the motor cover by removing the 4 retaining screws

Finishing it off

20. Follow the belt tensioning and alignment guide: HERE

21. Follow the belt lubrication guided video: HERE

 

Was this helpful?

Contact NoblePro Support

Need help? Start your support request online and we’ll connect you to the Support Team.